Table of Contents
Advertisement
Wiring for TMCC or LEGACY
T
o power your accessory in the Command Control and LEGACY environments, you will
need an SC-2 (6-22980), an ASC (6-14182), or an ASC2 (6-81639). You will also need
the included 8" 3-pin female pigtail and a transformer (6-14198). See figures 6 and 7 for
wiring.
Note
Refer to your CAB-1, CAB-1L, or LEGACY manual for remote instructions.
SC-2 wiring and operation
T
hree wires are needed to connect your accessory to the SC-2 and a separate accessory
transformer. Refer to Figure 6.
1. Attach a wire to the transformer Common/Ground/U terminal and connect it to the COMM
(common) position on the SC-2.
2. Connect the black wire of the pigtail to the AUX2 terminal on the SC-2.
3. Finally, connect the red wire of the pigtail to the transformer Power/A terminal.
AUX2 will make the two children swing. The swings will come to a gradual stop when
AUX2 is released.
Swing
Accessory
SC-2
Transfomer
Figure 6. Wiring an SC-2.
3-pin male
connector
ACC1
ACC2
ACC3
ACC4
Red wire
10
3-pin female
connector
Black wire
8" 3-pin
female pigtail
Advertisement
Table of Contents
