Table of Contents
Advertisement
Additional wiring options
Connecting your accessory to a transformer
T
o power your accessory using a CW-80 Transformer (6-14198)or any other power
supply, you will need the included 8" 3-pin female pigtail to connect to the transformer
terminals. Make sure that all connections are secure. Loose connections can produce
extremely high temperatures. For this reason, do not touch the terminals or track connections
during use. Also, do not locate scenery materials such as lichen or ground foam near the
terminals. See figure 5 on page 9.
1. Plug in the 3-pin male connector on the accessory to the 3-pin female slot
on the pigtail.
2. Loosen the red ACCESSORY thumbscrew terminal, then place the red wire
on the metal terminal bar. Still holding the wire end, tighten the red
thumbscrew until secure. Be sure that the wire is touching the metal post.
3. Loosen the black ACCESSORY thumbscrew terminal, then place the black
wire on the metal terminal bar. Still holding the wire end, tighten the
black thumbscrew until secure. Be sure that the wire is touching the metal post.
4. Plug the CW-80 Transformer into your wall outlet (120 volts).
5. Apply 12-14 volts of power by raising the orange throttle on the
transformer.
8
Advertisement
Table of Contents
