Table of Contents
Advertisement
Installation Instructions
STEP 2 (OPTION D)
Aligning the SLB-U on a Projector using direct
mounting option
Align the SLB-U on the projector, as follows:
1. Locate the mounting holes on your projector.
2. Using a Phillips screwdriver, remove foot bracket
screws and foot brackets (see Figure 11).
NOTE: Keep unused adjustable foot brackets and
attaching hardware in a safe for future use.
3. Align the SLB-U on the projector, as follows:
a. Place the SLB-U (10) on your projector.
b. Adjust the legs on the SLB-U (10) as needed.
Align the legs on the SLB-U with mounting holes
on your projector.
4. Attach the SLB-U to the projector, as follows:
a. Select the screw size that fits the threaded inserts
on your projector (see Table 6).
b. Select the washer that fits the selected screw.
c. Attach the SLB-U to the projector using the
selected fasteners in accordance with Table 6 (see
Figure 12). Do not tighten the screws at this time.
Table 6. SLB-U Mounting Hardware
ITEM
DESCRIPTION
90
M6 x 25mm Phillips
Pan Head Screw
100
M5
25
P
X
MM
HILLIPS
P
H
S
AN
EAD
CREW
110
M4 x 25mm Phillips
Pan Head Screw
120
M3
25
P
X
MM
HILLIPS
P
H
S
AN
EAD
CREW
QTY
NOTES
4
Used with M6 Flat
Washers (60)
4
4
Used with M4 Flat
Washers (70)
4
5. Attach the SLB-U to RPA (see Figure 2).
Figure 11. Remove Feet
Figure 12. Install the SLB-U on Projector
SLB-U
Swing legs inside for
close hole pattern
9
Advertisement
Table of Contents
