Table of Contents
Advertisement
Installation Instructions
STEP 3
Adjusting Foot Height on SLB-U
Adjust the feet on the SLB-U for height, as follows:
NOTE: Foot height is adjusted for a variety of reasons,
which includes, but is not limited to, ventilation,
uneven projector surface, and to level the RPA
mounting plate.
1. Visually check the height of the RPA mounting plate
on the SLB-U. Review the reasons for foot height
adjustment, noted above.
2. Loosen the screw and adjust the foot that is attached
to the adjustable leg on the SLB-U (see Figure 13).
3. Adjust foot height as needed. If necessary, use a level
to verify that the RPA mounting plate is level.
4. Tighten the screw.
5. Repeat procedure for each foot as needed until the
feet on the SLB-U are adjusted to your satisfaction.
STEP 4
Positioning the SLB-U on the
Projector
Position the on the SLB-U on your projector, as follows:
NOTE: When positioning the SLB-U on your projector,
take into consideration the weight of the
projector and its center of gravity.
1. Slide the SLB-U into the position that you want on
your projector.
Failure to tighten the screws after positioning the
SLB-U on your projector could result in damage
to your projector.
2. Tighten the screws shown in Figure 14.
NOTE: For further instructions, see the applicable
RPA and/or Smart-lift™ instruction manuals.
10
WARNING
Level the
RPA
Mounting
Plate
Figure 13. Adjust Leg Height on SLB-U
Position SLB-U on the
projector. Tighten the
screws.
Figure 14. Position the SLB-U and
Tighten the Screws
SLB-U
Loosen the screw.
Adjust foot height.
Tighten the screw
Advertisement
Table of Contents
