Table of Contents
Advertisement
Installation Instructions
STEP 2 (OPTION C)
Aligning the SLB-U (using horizontal slot) on a
Projector with 3 Mounting Holes
Align the SLB-U on the projector, as follows:
1. Locate the three mounting holes on your projector.
2. Using a Phillips screwdriver, remove two screws, hex
nuts, and two adjustable legs from the SLB-U (10)
(see Figure 9).
NOTE: Keep unused adjustable leg and attaching
hardware in a safe for future use.
3. Select the applicable horizontal slot to install the
adjustable leg (see Figure 9 and Figure 10).
4. Loosen the three remaining head screws. Do not
remove the screws.
NOTE: If necessary, use the measurements that you
recorded when you completed Step 1,
"Measuring the Mounting Holes On Projector" to
help align the adjustable legs with the mounting-
hole pattern on the projector.
5. Align the SLB-U on the projector, as follows:
a. Place the SLB-U (10) on your projector.
b. Adjust the legs on the SLB-U (10) as needed.
Align the adjustable feet on the SLB-U with
mounting holes on your projector.
6. Attach the SLB-U to the projector, as follows:
c. Select the screw size that fits the threaded inserts
on your projector (see Table 5).
d. Select the washer that fits the selected screw.
e. Attach the SLB-U to the projector using the
selected fasteners in accordance with Table 5. Do
not tighten the screws at this time.
Table 5. SLB-U Mounting Hardware
ITEM
DESCRIPTION
20
6
12
M
X
MM SCREW
30
5
12
M
X
MM SCREW
40
4
12
M
X
MM SCREW
50
3
10
M
X
MM SCREW
60
6
M
FLAT WASHER
70
4
M
FLAT WASHER
10-24
80
THUMB NUT
8
QTY
NOTES
4
60
USE ITEM
WITH
20
30
ITEMS
AND
4
4
70
USE ITEM
WITH
40
50
ITEMS
AND
4
4
4
USE TO ATTACH
4
-
SLB
U TO RPA
7. Attach the SLB-U to RPA (see Figure 2).
Screw
Hex nut
Install adjustable leg
in horizontal slot.
Figure 9. Align the SLB-U on 3-Hole Projector Using
Horizontal Slots
Screw
Figure 10. Align the SLB-U on 3-Hole Projector
Using Horizontal Slots
Loosen screws. Adjust legs
on SLB-U, as needed. Align
legs on SLB-U with
mounting holes on projector.
10
OR
Loosen screws. Adjust legs
on SLB-U, as needed. Align
legs on SLB-U with
mounting holes on projector.
Install adjustable leg
in horizontal slot.
Hex nut
SLB-U
Advertisement
Table of Contents
