YASKAWA MP2000 Series User Manual page 40

3.3 Setting the Communication Manager
3.3.2 Setting the Communication Manager
5.
Save the settings and restart the Communication Manager.
Refer to 3.3.2 ( 4 ) Saving the Communication Port Settings and Restarting the Communication Manager on
page 3-13 for the procedure.
( 3 ) Setting the Ethernet (LP) Communication Port
These settings are optimum for performing engineering via the Ethernet communication port of the 263IF-01
Module.
Since the engineering message size is expanded at the Ethernet (LP) communication port compared with the conven-
tional Ethernet communication port (CP218/Ethernet), high-speed engineering communication is possible.
1.
In the Communication Manager window, double-click the number in the Logical PT column of a line
which has not been set ([3] and greater in the figure below) to display the Logical Port Setting dialog
box.
2.
Select Ethernet (LP) under Port Kind in the Logical Port Setting dialog box and click the Detail but-
ton.
The CP-218/Ethernet (LP) Port Setting dialog box will be displayed.
3.
Enter the IP address of the computer in the IP Address (First) box, and confirm that the rest of the set-
tings are as shown here. Then click the OK button.
The CP-218/Ethernet (LP) Port Setting dialog box is closed and the display will return to the Logical Port
Setting dialog box.
3-12