Table of Contents
Advertisement
10. Click the
ble, download the project to its Flash memory, reset the MCU, and start running the
application. A message similar to the one shown in Figure 18 is displayed.
Figure 18. Message Displayed upon Connecting to Target MCU
11. The red LED (D3) should start flashing 1 second on, 1 second off while the applica-
tion waits for the PIR sensor to stabilize.
12. If a serial terminal application is running and connected to the Zilog USB Serial
Device, the messages shown in Figure 19 will be displayed.
UM028901-0318
Z8F6481 ZMOTION
Figure 17. Build Succeeded Message
icon. ZDS II will connect to the target MCU through the USB SmartCa-
Go
®
Library Development Kit
Using ZDS-II to Download and Debug a Project
User Manual
22
Advertisement
Table of Contents
