Operation - Sime Benchmark User Instructions

OPERATION

During operation, the cover of the controller must be kept closed.
– Selection of operating mode
(grey reference buttons)
– Info button
(grey reference button)
– Temperature correction
4
Automatic operation: the heating functions automatically in line with the set heating
programme. The programme can be switched-off for brief periods by pressing the
presence button.
Manual operation: the heating functions manually in line with the selection of the
presence button.
Availability: heating is deactivated.
Day, time, ambient temperature
External temperature *
Domestic hot water temperature *
Before correcting the temperature on the regulator, the thermostat valve temperatures
(if provided) must be set to the required temperature first.
If your house is too warm or too cold, you can easily correct the set tempe-
rature by adjusting the temperature knob.
Rotating the knob towards the + sign increases the set tempera-
ture by approximately 1°C per notch.
Rotating the knob towards the – sign decreases the set tempera-
ture by approximately 1°C per notch.
Before re-correcting, allow the temperature to stabilise.
Note: The temperature knob can only be used to correct the set temperature, while the redu-
ced temperature remains unaltered.
The required operating mode is selected by
pressing the relative button with the corre-
sponding symbol. The selection is displayed
with the symbol
Each time the info button is pressed, the fol-
lowing are displayed one after the other. The
temperature sensor continues to function
independently of the display
* This information appears only when the
relative sensor is connected or if it is tran-
smitted by the boiler regulator.