Table of Contents
Advertisement
4 Troubleshooting
4.1 Address in not set
If you linked a variable on a diagram but didn't set its address you will
get a message like in the figure below.
In this case you need to set variables address. To do that, see
4.2 Connection error
If you have a connection error during uploading or downloading a
configuration you will get a message like shown in the figure below.
Figure 73 - Unknown address
3 .7.3.
49
Advertisement
Table of Contents
Need help?
Do you have a question about the Expertmeter PM180 and is the answer not in the manual?