Display Assembly - HP Pavilion 15 Maintenance And Service Manual

Display assembly

NOTE: The display assembly is spared at the subcomponent level. For display assembly spare part
information, see the individual removal subsections.
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the optical drive (see
5. Remove the bottom cover (see
6. Remove the battery (see
Remove the display assembly:
1. Disconnect the display cable from the system board ZIF connector (1).
2. Disconnect the WLAN antenna cables (2) from the terminals on the WLAN module.
NOTE:
WLAN antenna cable labeled "2/AUX" connects to the WLAN module "Aux" terminal.
3. Release the display panel from the retention clips (3) and routing channel built into the left speaker.
4. Release the WLAN antenna cables from the retention clips (3) and routing channel built into the right
speaker.
Optical drive on page
Bottom cover on page
Battery on page
The WLAN antenna cable labeled "1/MAIN" connects to the WLAN module "Main" terminal. The
28).
31).
34).
Component replacement procedures 35