Maintenance Indicators - Sharp XR-1X Operation Manual

Maintenance Indicators

■ The warning lights (ON/STANDBY button, lamp indicator and temperature warning indicator) on
the projector indicate problems inside the projector.
■ If a problem occurs, either the temperature warning indicator or the lamp indicator will illuminate
red, and the projector will enter standby mode. After the projector has entered standby mode,
follow the procedures given below.
ON/STANDBY button
Lamp indicator
Temperature warning indicator
About the temperature warning indicator
If the temperature inside the projector increases, due to blockage of the air vents, or the setting location,
" " will illuminate in the lower left corner of the picture. If the temperature keeps on rising, the lamp
will turn off and the temperature warning indicator will blink, the cooling fan will run, and then the projec-
tor will enter standby mode. After "
54.
About the lamp indicator
■ When the remaining lamp life becomes 5% or less,
displayed on the screen. When the percentage becomes 0%, it will change to
automatically turn off and then the projector will automatically enter standby mode. At this time, the
lamp indicator will illuminate in red.
■ If you try to turn on the projector a fourth time without replacing the lamp, the projector will
not turn on.
" appears, be sure to perform the measures described on page
(yellow) and "Change The Lamp" will be
(red), the lamp will
53