Connecting To A Computer; Projector - Sharp XR-1X Operation Manual

Connecting to a Computer

Before connecting, be sure to unplug the power cord of the projector from the AC outlet and
turn off the devices to be connected. After making all connections, turn on the projector
and then the other devices. When connecting a computer, be sure that it is the last device to
be turned on after all the connections are made.
Be sure to read the operation manuals of the devices to be connected before making connections.
To audio output terminal
To RGB output terminal
To USB terminal
* ø3.5 mm stereo or
mono audio cable
(commercially
available or
available as Sharp
service part
* When using the ø3.5 mm mono audio cable, the volume level will be half of
QCNWGA038WJPZ)
when using the ø3.5 mm stereo audio cable.
Note
• When connecting with USB cable, you can use the remote control as a mouse for controlling cursor.
See page 33.
• See page 59 "Computer Compatibility Chart" for a list of computer signals compatible with the projec-
tor. Use with computer signals other than those listed may cause some of the functions to not work.
• A Macintosh adaptor may be required for use with some Macintosh computers. Contact your near-
est Macintosh Dealer.
• Depending on the computer you are using, an image may not be projected unless the signal
output setting of the computer is switched to the external output. Refer to the computer opera-
tion manual for switching the computer signal output settings.
"Plug and Play" function (when connecting to a 15-pin terminal)
■ This projector is compatible with VESA-standard DDC 1/DDC 2B. The projector and a VESA
DDC compatible computer will communicate their setting requirements, allowing for quick
and easy setup.
■ Before using the "Plug and Play" function, be sure to turn on the projector first and the
connected computer last.
Note
• The DDC "Plug and Play" function of this projector operates only when used in conjunction with a
VESA DDC compatible computer.
Supplied
accessory
RGB/USB Cable
RGB/USB Cable
To USB terminal
To INPUT1
To AUDIO
terminal
INPUT terminal
23