Maintenance Indicators - Sharp Conference Series Operation Manual

Maintenance Indicators

■
The warning lights (power indicator, lamp indicator and temperature warning indicator) on the
projector indicate problems inside the projector.
■
If a problem occurs, either the temperature warning indicator or the lamp indicator will
illuminate red, and the projector will enter Standby mode. After the projector has entered
Standby mode, follow the procedures given below.
Top View
About the temperature warning indicator
If the temperature inside the projector increases, due to blockage of the air vents, or the setting
location, the temperature warning indicator will blink. And if the temperature keeps on rising,
" " will illuminate in the lower left corner of the picture with the temperature warning
indicator blinking. If this state continues, the lamp will turn off, the cooling fan will run and then
the projector will enter Standby mode. When you fi nd the temperature warning indicator
blinking, be sure to perform the measures described on page 71.
About the lamp indicator
■
When the remaining lamp life becomes 5% or less,
be displayed on the screen. When the percentage becomes 0%, it will change to
lamp will automatically turn off and then the projector will automatically enter Standby mode.
At this time, the lamp indicator will illuminate in red.
■
If you try to turn on the projector a fourth time without replacing the lamp, the
projector will not turn on.
Indicators on the Projector
Power indicator
Lamp indicator
Temperature
warning indicator
70
Temperature warning indicator
Lamp indicator
Power indicator
Red on Normal (Standby)
Green on Normal (Power on)
Red blinks Abnormal (See page 71.)
Green blinks Normal (Cooling)
Green on Normal
Green blinks The lamp is warming up.
Red on The lamp is shut down abnormally or requires to be
changed. (See page 71.)
Off Normal
Red on/Red blinks The internal temperature is abnormally high. (See page 71.)
(yellow) and "Change The Lamp." will
(red), the