Maintenance Indicators - Sharp AN-K2LP Operation Manual

Maintenance Indicators

■ The warning lights on the projector indicate problems inside the projector.
■ If a problem occurs, either the temperature indicator or the lamp indicator will illuminate red, and
the projector will enter the standby mode. After the projector has entered the standby mode, follow
the procedures given below.
About the temperature warning indicator
If the temperature inside the projector increases, due to blockage of the air vents, or the setting location,
" " will illuminate in the lower left corner of the picture. If the temperature keeps on rising, the lamp will
turn off and the temperature warning indicator will blink, the cooling fan will run for a further 90 seconds, and
then the projector will enter the standby mode. After "
described on page 55.
About the lamp indicator
■ When the remaining lamp life becomes 5% or less, "
displayed on the screen. When the percentage becomes 0%, it will change to "
automatically turn off and then the projector will automatically enter the standby mode. At this time,
the lamp indicator will illuminate in red.
■ If you try to turn on the projector a fourth time without replacing the lamp, the projector will not turn on.
-54
Maintenance Indicators
Power indicator
Lamp indicator
Temperature warning indicator
" appears, ensure to perform the measures
" (yellow) and "Change The Lamp." will be
" (red), the lamp will