Projector - Sharp XR-1X Operation Manual

Image Projection (Continued)
2 Adjusting the Height
The height of the projector can be ad-
justed using the adjustment feet at the
front and rear of the projector.
When the screen is in a higher position
than the projector, the projection image
can be made higher by adjusting the

projector.

1
Lift the projector to adjust its
height while pressing the HEIGHT
ADJUST button.
2
Remove your hands from the
HEIGHT ADJUST button of the
projector after its height has been
finely adjusted.
• The angle of projection is adjustable up
to 7.5 degrees from the surface on which
the projector is placed.
3
Use the rear adjustment foot to
make the projector level.
• The projector is adjustable ±1 degree
from the standard position.
Note
• When adjusting the height of the projector,
trapezoidal distortion occurs. When "Auto
Keystone" is set to "On", keystone correction
functions automatically to correct trapezoidal
distortion. When you want to adjust the auto-
matically corrected image, use the manual
keystone correction. (See page 44.)
3 Adjusting the Screen Size
You can adjust the screen size using
the zoom knob on the projector.
28
Rear adjustment foot
Info
• Do not apply too much pressure on the pro-
jector when the front adjustment foot comes
out.
• When lowering the projector, be careful not to
get your fingers caught in the area between
the adjustment foot and the projector.
zoom
in
zoom
out
Zoom Knob
HEIGHT
ADJUST button