Lamp/Maintenance Indicators - Sharp XG-P25XU Operation Manual

Lamp/Maintenance Indicators

Maintenance Indicators
POWER LAMP
indicator REPLACEMENT
indicator
Maintenance Indicator
TEMPERATURE
WARNING indicator
LAMP REPLACE-
MENT indicator
POWER indicator
• If the TEMPERATURE WARNING indicator lights up, follow the above possible solutions and then wait until the projector has
cooled down completely before turning the power back on. (At least 5 minutes.)
• If the power is turned off and then turned on again, as during a brief rest, the LAMP REPLACEMENT indicator may be
triggered, preventing the power from going on. Should this occur, take the power cord out of the wall outlet and put it back
in again.
Lamp
The lamp in this projector operates for approximately 1,500 cumulative hours, depending on the usage environ-
ment. It is recommended that the lamp be replaced after 1,400 cumulative hours of use or when you notice a
significant deterioration of the picture and color quality. The lamp usage time can be checked with the On-screen
Display. (see page
51
CAUTION
• Intense light hazard. Do not attempt to look into the aperture and lens while the projector is operating.
• As the usage environment can vary significantly, the projector lamp may not operate for 1,500 hours.
Condition
The LAMP REPLACEMENT
indicator lights up red, and "LAMP"
and " " will blink in yellow in the
lower-left corner of the picture.
A significant deterioration of the
picture and color quality occurs.
The power will automatically turn
off and the projector will enter
standby mode.
"LAMP" and " " will blink in red in
the lower-left corner of the picture,
and the power will turn off.
E-61
XG-P25X/CD (E)-g 61
TEMPERATURE
WARNING
indicator
Condition Problem
• Blocked air intake.
The internal
temperature is
abnormally high.
• Clogged air filter.
• Cooling fan breakdown.
• Internal circuit failure.
• Burnt-out lamp.
The lamp does not
light up. • Lamp circuit failure.
The lamp requires • Lamp has been used for
replacement. over 1,400 hours.
The POWER • The filter cover is open.
indicator flashes in
red when the
projector is on.
.)
• Lamp has been used for over 1,400
hours.
• Lamp has been used for over 1,500
hours.
• The warning lights on the projector indicate problems
inside the projector.
• There are two warning lights: a TEMPERATURE
WARNING indicator which warns that the projector is
too hot, and a LAMP REPLACEMENT indicator which
lets you know when to change the lamp.
• If a problem occurs, either the TEMPERATURE
WARNING indicator or the LAMP REPLACEMENT
indicator will light up red. After turning off the power,
follow the procedures given below.
• Relocate the projector to an area with
proper ventilation.
• Clean the filter.
(See page
• Take the projector to your nearest Sharp
Authorized LCD Projector Dealer or Service
Center for repair.
• Carefully replace the lamp. (See pages
and .)
63
• Take the projector to your nearest Sharp
Authorized LCD Projector Dealer or Service
Center for repair.
• Securely install the filter cover.
• If the POWER indicator flashes even when
the filter cover is securely installed, contact
your nearest Sharp Authorized LCD
Projector Dealer or Service Center for
advice.
Problem
• Purchase a replacement lamp unit
(lamp/cage module) of the current
type BQC-XGP25X//1 from your
nearest Sharp Authorised LCD
Projector Dealer or Service Center.
• Replace the lamp. (See pages
and
have the lamp replaced at your
nearest Sharp Authorised LCD
Projector Dealer or Service Center.
02.3.19, 7:12 PM
Possible Solution
.)
64
62
Possible Solution
62
.) If you wish, you may
63