Setting Up the Projector Network Environment ("Network" Menu)
1 Setting a Password
If you do not want others to change the setting
for the "Network" menu, set a password.
a Setting a Password
1
1
Select "Password", then press
ENTER or Q.
•
The screen for entering the password
appears.
Setting the Password
Old Password
New Password
Reconfirm
2
2
Press P or R to set the fi rst digit
in "New Password", then press Q.
3
3
Enter the remaining 3 digits, then
press ENTER.
To return to the previous digit, press O.
•
4
4
Enter the same password in
"Reconfi rm", then press ENTER.
•
The status for "Password" changes to
"Enable".
Note
•
Once the password is set, you must enter the
password to change the "Network" menu
settings.
a Changing the Password
1
1
Select "Password", then press
ENTER or Q.
•
The screen for entering the password
appears.
54
Pict.
SIG
SCR
PRJ1
Password
DHCP Client
TCP/IP
Reset Network Setting
Restart Network
IP Address
X X X . X X X . X X X . X X X
MAC Address X X : X X : X X : X X : X X : X X
Projector
X X - X X X X
Link
Disconnected
SEL./ADJ.
ENTER
2
2
3
3
4
4
Network
–
– – –
–
– – –
– – – –
•
•
If you forget the password, perform the
following procedure to delete it, then set a
new password.
On the projector, press
Menu operation n Page
PRJ2
Network
Disable
Off
END
Enter the password in "Old
Password" using P, R, Q and O,
then press ENTER.
Enter the password in "New
Password" using P, R, Q and O,
then press ENTER.
Enter the same password again
in "Reconfi rm" using P, R, Q and
O, then press ENTER.
Note
If you do not need the password protection
for the "Network" menu settings anymore,
press ENTER without entering the new
password in steps 3 and 4.
To cancel the password settings, press
RETURN.
If you forget the password
Note
•
If ENTER is held down for more than 5
seconds, the operation buttons on the
projector will be locked. (See page 52.)
•
You cannot use the buttons on the
remote control to delete the password.
40
.