Sharp Notevision PG-D2870W Operation Manual page 21

4. Adjust the projected image with the Setup Guide
1
After the projector turns on, the Setup Guide appears.
(When "Setup Guide" is set to "On". See page 49.)
2
Follow the steps in the Setup Guide and adjust the focus, height (angle) and picture size.
3
After adjusting the focus, height (angle) and picture size, press ENTER to fi nish the
Setup Guide.
5. Correct trapezoidal distortion
Correcting trapezoidal distortion using Keystone Correction.
On the remote control
6. Select the Input mode
Press INPUT P/R to display the INPUT list. Use INPUT P/R to select the Input mode,
and use O/Q to select the audio input terminal.
On the
projector
On the remote
control
7. Turn the computer on
8. Turn the power off
Press STANDBY/ON on the projector or STANDBY on the remote control, and then press
the button again while the confi rmation message is displayed to put the projector into
Standby mode.
On the
projector
Shrinks
upper side.
INPUT list
INPUT
1 COMPUTER1
2 MONITOR OUT
HDMI
H
On the remote
control
Audio
On-screen display
P. 27
Shrinks
lower side.
P. 29
On the
projector
On the remote
control
P. 30
P. 26
17