Setting Up The Projector Network Environment ("Net." Menu); Setting A Password - Sharp XG-SV200X Operation Manual

Setting Up the Projector Network Environment ("Net." Menu)

Picture Audio SIG
Password
DHCP Client
TCP/IP
Reset Network Setting
Restart Network
IP Address XXX.XXX.XXX.XXX
MAC Address XX:XX:XX:XX:XX:XX
Projector XX-XXXX
SEL./ADJ.
RETURN

1 Setting a Password

If you do not want others to change the setting
for the "Net." menu, set a password.
a Setting a Password
1 1 Select "Password", then press Q.
• The screen for entering the password
appears.
Setting the Password
Old Password
New Password
Reconfirm
2 2 Press P or R to set the fi rst digit
in "New Password", then press Q.
3 3
Enter the remaining 3 digits, then
press ENTER.
To return to the previous digit, press O.
•
4 4
Enter the same password in
"Reconfi rm", then press ENTER.
• The status for "Password" changes to
"Enable".
Note
• Once after the password is set, you must
enter the password to change the "Net." menu
settings.
SCR PRJ Net.
Disable
Off
ENTER
END
Net.
– – – –
– – – –
– – – –
Menu operation n Page
a Changing the Password
1 1 Select "Password", then press Q.
• The screen for entering the password
appears.
2 2
Enter the password in "Old
Password" using P, R, Q and O,
then press ENTER.
3 3
Enter the password in "New
Password" using P, R, Q and O,
then press ENTER.
4 4
Enter the same password again
in "Reconfi rm" using P, R, Q and
O, then press ENTER.
Note
• If you do not need the password protection for
the "Net." menu settings anymore, press
ENTER without entering new password in
steps 3 and 4.
• To cancel the password settings, press
RETURN.
If you forget the password
If you forget the password, perform the
following procedure to delete it, then set a
new password.
On the projector, press
Note
• If ENTER is held down for more than 5
seconds, the operation buttons on the
projector will be locked. (See page 58.)
• You cannot use the buttons on the
remote control to delete the password.
46
.
61