Setting Up The Projector Network Environment ("Network" Menu); Setting A Password - Sharp Notevision PG-F320W Operation Manual

Setting up the Projector Network Environment ("Network" menu)

1 1 1 1 1 Setting a Password

If you do not want others to change the setting
for the "Network" menu, set a password.
a Setting a Password
1
Select "Password", then press
ENTER or Q.
• The screen for entering the password
appears.
Setting the Password
Old Password
New Password
Reconfirm
2
Press P or R to set the first digit
in "New Password", then press Q.
3
Enter the remaining 3 digits, then
press ENTER.
• To return to the previous digit, press O.
4
Enter the same password in "Re-
confirm", then press ENTER.
• The status for "Password" changes to
"Enable".
Note
• Once after the password is set, you must en-
ter the password to change the "Network"
menu settings.
a Changing the Password
1
Select "Password", then press
ENTER or Q.
• The screen for entering the password
appears.
Pict. SCR PRJ
1
Password
2 DHCP Client
3
TCP/IP
MAC Address X X : X X : X X : X X : X X : X X
4
Projector X X - X X X X
SEL./ADJ.
Network
– – – –
– – – –
– – – –
Network Help
Disable
Off
ENTER END
2
Enter the password in "Old Pass-
word" using P, R, Q and O, then
press ENTER.
3
Enter the password in "New Pass-
word" using P, R, Q and O, then
press ENTER.
4
Enter the same password again in
"Reconfirm" using P, R, Q and O,
then press ENTER.
Note
• If you do not need the password protection
for the "Network" menu settings anymore,
press ENTER without entering new password
in steps 3 and 4.
• To cancel the password settings, press
RETURN.
If you forget the password
If you forget the password, perform the fol-
lowing procedure to delete it, then set a new
password.
On the projector, press
S T S T
→ → →
Note
• If ENTER is held down for more than 5 sec-
onds, the operation buttons on the projec-
tor will be locked. (See page 48.)
• You cannot use the buttons on the remote
control to delete the password.
Menu operation n Page
S T U
→ → →
.
39
49