Setting Up The Projector Network Environment ("Network" Menu); Setting A Password - Sharp XG-MB67X Operation Manual

Setting up the Projector Network Environment ("Network" menu)

1 Setting a Password

1 1 1 1
If you do not want others to change the setting
for the "Network" menu, set a password.
a Setting a Password
1
Select "Password", then press
hENTER or Q.
• The screen for entering the password
appears.
Setting the Password
Old Password
New Password
Reconfirm
2
Press P or R to set the first digit
in "New Password", then press Q.
3
Enter the remaining 3 digits, then
press hENTER.
• To return to the previous digit, press O.
4
Enter the same password in "Re-
confirm", then press hENTER.
• The status for "Password" changes to
"Enable".
Note
• Once after the password is set, you must en-
ter the password to change the "Network"
menu settings.
a Changing the Password
1
Select "Password", then press
hENTER or Q.
• The screen for entering the password
appears.
Pict. SCR PRJ
Password
DHCP Client
TCP/IP
MAC Address 0 8 : 0 0 : 1 F : B 1 : B 7 : 7 4
Projector XG-MB67X
SEL./ADJ. ENTER
Network
– – – –
– – – –
– – – –
Menu operation n Page
Network Help
Disable
On
END
2
Enter the password in "Old Pass-
word" using P, R, Q and O, then
press hENTER.
3
Enter the password in "New Pass-
word" using P, R, Q and O, then
press hENTER.
4
Enter the same password again in
"Reconfirm" using P, R, Q and O,
then press hENTER.
Note
• If you do not need the password protection
for the "Network" menu settings anymore,
press hENTER without entering new pass-
word in steps 3 and 4.
• To cancel the password settings, press l
RETURN.
If you forget the password
If you forget the password, perform the fol-
lowing procedure to delete it, then set a new
password.
On the projector, press
S T S T
→ → → →
Note
• If TENTER is held down for more than 5
seconds, the operation buttons on the pro-
jector will be locked. (See page 48.)
• You cannot use the buttons on the remote
control to delete the password.
40
S T U
→ →
.
49