Common Operating Problems - Xerox X2 User Manual

Trouble isolation procedures (con't)

Common operating problems

Symptom
Cutter does not cut
cleanly
Cutter does not operate
"Ink Empty" is displayed
when the ink exists
Poor image quality
Banding
Blurred print
Appendix A: In Case of Difficulty
Computer interface test (con't)
4. In the SCSI Select utility, verify that the printer
has the same SCSI ID set as is being addressed
by the host computer.
5. In the SCSI Select utility, set the transfer rate to
10 MB/sec and disable disconnect.
6. Print from the host computer to ensure that all of
the elements are connected and working
properly.
7. If you are able to print using commands from the
host computer, the computer/printer interface is
working properly. The problem probably exists
elsewhere. Contact your service representative
for assistance.
The following are some common operating problems with symptom
descriptions and suggested actions.
Potential Problem
--
Incorrect cutter setting at
operation panel
Cutter is stuck
--
--
Using the wrong side of the
media
Using incorrect media
Suggested Solution
Replace the cutter.
Check the cutter mode. If
the mode is set to NO CUT,
set the mode to NORMAL
CUT.
Manually move the cutter to
the right
Ensure that the ink cap is fully
inserted into the ink bottle.
Change the print mode to
print in higher mode.
Perform the adjustment
procedure in Media Attribute,
Magnification
Ensure the media is properly
installed in the printer.
Ensure that 720 dpi printing
is not performed on media
designed for 360 dpi printing
or vice versa.
51