Starting The Take-Up Roller; Operating The Printer From Rip Software - Xerox X2 User Manual

Using the take-up roller (con't)
Printing surface

Operating the printer from RIP software

Operations
Setup the take-up assembly (con't)
3. Set the FLANGE on the plastic roller bearing on
the right side.
4. Set the left FLANGE on the plastic roller bearing.
If you need to adjust the length, do steps 1 and 2
again. (Note that the end caps for the take-up
roller are black versus the green caps for the
media roller. Use these for optimum
performance.)
5. At the operations panel, enable the take-up roll.
a. Press the Menu button (top button) to enter
menu mode.
b. Press the button associated with the Set
menu option.
c. Press the left arrow button
the Winding direction option.
d. Set to the desired direction: Image In or
Image Out.

Starting the take-up roller

1. When the printed media passes completely over
the platen and emerges out the exit chute, guide
the media over or under the take-up roll and
tape it to the roll.
2. Monitor the media until it has rolled once around
the take-up roll. From this point on, the media
will wind up automatically.
Instructions for operating the printer using the host computer's digital
front end (DFE) program are covered in associated DFE software
manuals or release notes.
4 times to display
27