Safety Precautions - Infineon EVAL-M1-05F804 User Manual

EVAL-M1-05F804 User Manual
iMOTION™ Modular Application Design Kit

Safety precautions

1 Safety precautions
In addition to the precautions listed throughout this manual, please read and understand the following
statements regarding hazards associated with development systems.
Table 1 Precautions
Attention: The ground potential of the EVAL-M1-05F804 system is biased to a negative DC
Attention: EVAL-M1-05F804 system contains DC bus capacitors which take time to
Attention: Only personnel familiar with the drive and associated machinery should plan
Attention: The surfaces of the drive may become hot, which may cause injury.
Attention: EVAL-M1-05F804 system contains parts and assemblies sensitive to
Attention: A drive, incorrectly applied or installed, can result in component damage or
User Manual
bus voltage potential. When measuring voltage waveform by oscilloscope, the
scope's ground needs to be isolated. Failure to do so may result in personal
injury or death. Darkened display LEDs are not an indication that capacitors
have discharged to safe voltage levels.
discharge after removal of the main supply. Before working on the drive
system, wait three minutes for capacitors to discharge to safe voltage levels.
Failure to do so may result in personal injury or death. Darkened display LEDs
are not an indication that capacitors have discharged to safe voltage levels.
or implement the installation, start-up and subsequent maintenance of the
system. Failure to comply may result in personal injury and/or equipment
damage.
Electrostatic Discharge (ESD). Electrostatic control precautions are required
when installing, testing, servicing or repairing this assembly. Component
damage may result if ESD control procedures are not followed. If you are not
familiar with electrostatic control procedures, refer to applicable ESD
protection handbooks and guidelines.
reduction in product lifetime. Wiring or application errors such as under sizing
the motor, supplying an incorrect or inadequate AC supply or excessive
ambient temperatures may result in system malfunction.
2 <Revision 1.1>
<2018-07-09>