Table of Contents
Advertisement
Filter Change Procedure
NOTE: This system is equipped with an internal shut-off
valve.
1. Turn cartridge slowly to the left, about 1/4 turn, until
it stops (when arrows line up). At this position, both
inlet and outlet ports are closed and water pressure
has been relieved.
2. Pull used cartridge straight down and discard. Note:
There may be a small amount of residual water drain-
age after pressure is relieved and during cartridge
removal.
3. Moisten o-ring with a food grade lubricant and push
new cartridge into filter head. Turn cartridge 1/4 turn
to the right until it stops (when arrows line up). Top
surface of cartridge will become flush with bottom of
the head when fully engaged.
4. Open downstream valve (if installed) and flush new
filter cartridge for two minutes, expelling any trapped
air and carbon fines. Water may run cloudy with air
but will quickly clear.
INSTALLATION
8
Figure 5
Advertisement
Table of Contents
