Daylight Saving Time Examples; Select A Display Language - Cisco 8831 Administration Manual

Localize Your Conference Phone
The save-time value is the number of hours, minutes, and/or seconds to add to the current time during
DST.

Daylight Saving Time Examples

The following example configures daylight saving time for the U.S, adding one hour starting at midnight
on the first Sunday in April and ending at midnight on the last Sunday of October; add 1 hour (USA,
North America):
The following example configures daylight saving time for Egypt, starting at midnight on the last Sunday
in April and ending at midnight on the last Sunday of September:
The following example configures daylight saving time for New Zealand (in version 7.5.1 and higher),
starting at midnight on the first Sunday of October and ending at midnight on the third Sunday of March.
The following example reflects the new change starting in March. DST starts on the second Sunday in
March and ends on the first Sunday in November:
The following example configures the daylight saving time starting on the last Monday (before April 8)
and ending on the first Wednesday (after May 8.)

Select a Display Language

This section describes how to localize the display language on the conference phone. You can define up
to twelve languages, in addition to English, to be available and host the dictionaries for each of the
languages on the HTTP or TFTP provisioning server. Language support follows Cisco dictionary
principles.
Use the Language Selection parameter to select the phone default display language. The value must
match one of the languages supported by the dictionary server. The script (dx value) is as follows:
•
•
Defaults to blank; the maximum number of characters is 512. For example:
During startup, the phone checks the selected language and downloads the dictionary from the
TFTP/HTTP provisioning server indicated in the phone configuration. The dictionaries are available at
the support website. See
The end user can change the language of the phone on the phone by following these steps:
Press the Setup button.
Step 1
Cisco Unified IP Conference Phone 8831 for Third-Party Call Control Administration Guide
7-4
start=4/1/7/0:0:0;end=10/31/7/0:0:0;save=1
start=4/1/7;end=10/-1/7;save=1
start=4/1/7/0;end=10/-1/7/0;save=1
start=4/-1/7;end=9/-1/7;save=1 (Egypt)
start=10/1/7;end=3/22/7;save=1 (New Zealand)
start=3/8/7/02:0:0;end=11/1/7/02:0:0;save=1
start=4/-8/1;end=5/8/3;save=1
<Language_Selection ua="na">
</Language_Selection>
<Language_Selection ua="na"> Spanish
</Language_Selection>
Appendix B, "Related Documentation,"
Chapter 7 Configure Regional Parameters and Supplementary Services
for the website location.