Configure Cisco Discovery Protocol (Cdp); Configure Lldp-Med - Cisco 8831 Administration Manual

Unified ip conference phone for third-party call control
Hide thumbs Also See for 8831:
Table of Contents

Advertisement

Configure VLAN Settings

Configure Cisco Discovery Protocol (CDP)

CDP is negotiation-based and determines which VLAN the IP phone resides in. If you are using a Cisco
switch, Cisco discovery protocol (CDP) is available and is enabled by default. CDP:
If you are using a VLAN without CDP, you must enter a VLAN ID for the IP conference phone.

Configure LLDP-MED

The IP conference phones support Link Layer Discovery Protocol for Media Endpoint Devices
(LLDP-MED) for deployment with Cisco or other third-party network connectivity devices that use a
Layer 2 auto-discovery mechanism. Implementation of LLDP-MED is done in accordance with IEEE
802.1AB (LLDP) Specification of May 2005, and ANSI TIA-1057 of April 2006.
The IP conference phone operates as LLDP-MED Media End Point Class III devices with direct
LLDP-MED links to Network Connectivity Devices, according to the Media Endpoint Discovery
Reference Model and Definition (ANSI TIA-1057 Section 6).
The IP conference phone supports only the following limited set of TLVs as LLDP-MED Media
Endpoint device class III:
The outgoing LLDPDU contains all the above TLVs when if applicable. For the incoming LLDPDU, the
LLDPDU is discarded if any of the following TLVs are missing. All other TLVs are not validated and
ignored.
Cisco Unified IP Conference Phone 8831 for Third-Party Call Control Administration Guide
4-6
Obtains the protocol addresses of neighboring devices and discovers the platform of those devices.
Shows information about the interfaces your router uses.
Is media and protocol-independent.
Chassis ID TLV
Port ID TLV
Time to live TLV
Port Description TLV
System Name TLV
System Capabilities TLV
IEEE 802.3 MAC/PHY Configuration/Status TLV (for wired network only)
LLDP-MED Capabilities TLV
LLDP-MED Network Policy TLV (for application type=Voice only)
LLDP-MED Extended Power-Via-MDI TLV (for wired network only)
LLDP-MED Firmware Revision TLV
End of LLDPDU TLV
Chassis ID TLV
Port ID TLV
Time to live TLV
LLDP-MED Capabilities TLV
LLDP-MED Network Policy TLV (for application type=Voice only)
End of LLDPDU TLV
Chapter 4
Configure Security, Quality, and Network Features

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents