Table of Contents
Advertisement
1
Getting Started
44
Figure 24
Select the Sweep Mode
•
Press
you want the data to remain static for saving results or printing.
•
Press to
this mode, a measurement sweeps occurs approximately every 0.3
seconds (86122C Option 110) or every 0.5 seconds (86122C Option
100) or every 0.6 seconds (86120D). This is useful if you want the data
to be continuously updated.
You can also set up data logging to perform measurement sweeps at any
desired interval. The green SWP indicator in the lower right-hand corner is
lit when a measurement is being acquired.
to initiate one measurement sweep. This is useful if
continuously measure the input spectrum. In
Keysight 86120D and 86122C Multi-Wavelength Meters User's Guide
Advertisement
Table of Contents
