Table of Contents
Advertisement
S
NOWBLOWER
The snowblower is assembled at the factory, however, snowblower kit must be assembled. Use the
present manual and lay out all parts for assembly. Separate bolts and nuts into various sizes. After
assembly, torque all the bolts according to the Torque Specification Table enclosed at the end of the
manual.
Chute Installation
Install chute according to the instructions supplied with the chosen rotation – manual or
hydraulic.
Driveline Installation
1. Remove paint from snowblower gearbox drive
shaft and grease driveline sliding surfaces
and yoke.
2. Remove the bolt of the yoke and slide
driveline yoke over drive shaft using sliding
action of the driveline. Make sure the driveline
is well secured to the drive shaft by replacing
the bolt and tightening it according to the
torque specification table.
Snowblower Installation
1. Attach tractor lower hitch arms (items 1) to
snowblower attaching plates using the hitch
pins and secure with linchpins (items 2).
2. Install the tractor upper hitch (item 3) on the
upper hole of snowblower (item 5) attaching
plates using tractors pins and linchpins (items
4).
3. Adjust snowblower using the tractor upper
hitch so that it runs level.
4. Set the tractor anti-sway turnbuckles so the
snowblower does not sway.
CAUTION:
snowblower driveline to tractor drive shaft,
make sure driveline is not too long in raised,
lowered and middle position. If the driveline
is too long it must be shortened, to avoid
damaged to tractor.
5. Connect driveline to tractor drive P.T.O.,
make sure that the driveline yoke pin is
properly engaged.
OM 0277-A
ASSEMBLY
A
SSEMBLY
(Figure 1)
(Figure 2)
Before connecting
Figure 1
Figure 2
9
Hide quick links:
Advertisement
Table of Contents
