Table of Contents
Advertisement
MOUNTING & DISMOUNTING INSTRUCTIONS – ALL MODELS
Prior to operating your snowplow, review the Mount
and Dismount Instructions label on the back of the
driver-side moldboard.
MOUNT INSTRUCTIONS
Read Owner's Manual for Complete Instructions.
Receiving
WARNING: Keep fingers away from snowplow and tractor mounting points. Follow tractor labeling and owner's manual.
• Position the tractor close to the snowplow and align the mount points on the
tractor with the hooks on the back oscillating plate of the snowplow.
• Slowly raise the tractor mounting points until the tractor engages the snowplow
hooks. Turn the engine OFF.
• Engage both locking levers on the tractor by rotating
each handle 90° into a horizontal position. The tractor
locking levers shall insert into the snowplow
lever receiving holes.
• Attach all hydraulic hoses on the snowplow to the
auxiliary hydraulic connections located on the tractor.
On some tractor models, it may be necessary to initiate
an auxiliary hydraulic switch on the tractor prior to
operating the snowplow.
• Connect the snowplow wire harness to either the pistol
grip control or auxiliary electrical connection on the
tractor.
U.S. Patents 5,638,618; 5,899,007; 6,178,669; 6,276,076; 6,393,737; 6,408,549; 6,412,199; 6,442,877; 6,615,513; CAN Patents 2,184,922; 2,229,783; 2,259,508; 2,358,145; 2,358,354; 2,466,195; and other patents pending.
Lit. No. B64092, Rev. 09
Oscillating
Plate
Lever
Hole
NOTE: If at any time the Mount and Dismount
Instructions label, or any other label attached
to your snowplow, becomes illegible, promptly
replace it.
DISMOUNT INSTRUCTIONS
Read Owner's Manual for Complete Instructions.
Hook
• Lower the snowplow on a flat, level surface and turn the engine OFF.
• Disconnect the snowplow wire harness from the tractor.
• Disconnect all hydraulic hoses on the snowplow from the auxiliary hydraulic
connections located on the tractor.
23
Lever
Receiving
Hole
• Disengage both locking levers on the tractor by rotating
each handle 90° into a vertical position. The tractor
locking levers shall withdraw from the snowplow lever
receiving holes.
• Turn the engine ON. Slowly lower the tractor mounting
points until the tractor clears the snowplow hooks.
• Back the tractor away slowly.
Hook
Oscillating
Plate
44832
April 15, 2021
Advertisement
Table of Contents
