Adjustment At Time Of Parts Replacement; 2Stringing The Lifter Cable; Stringing The Lifter Cable; 3Points To Note When Mounting The Deck Pikcup Roller - Canon Paper Deck-V1 Portable Manual

2.2 Adjustment at Time of
Parts Replacement
2.2.1
Adjusting
Position of the Deck
Pickup Roller Releasing
Solenoid (SL101)
Take note of the positions of the two fixing screws [2]
of the solenoid with reference to the index on the
support plate before removing the deck pickup roller
releasing solenoid [1] from the support plate; or, mark
the position of the solenoid on the support plate with
a scriber.
If the solenoid is to be mounted on its own, be sure to
locate it in its initial position.
[2]
2.2.2 Stringing the Lifter
Cable
1) Check to make sure that the lifter drive shaft [1] and
the lifter [2] are fixed in place using a hex wrench
[3] and 2 long screwdrivers [4], respectively.
2) Fix the 4 cable fixing plates [5] in place to the lifter
using 2 screws each.
3) Hook the lifer cable [6] on the 4 pulleys [7] above.
4) Hook the ball of the lifter cable on the 2 front/rear
pulleys [8] of the lifter drive shaft; then, wind it
about 1.5 times along the groove of the pulley.
At this time, be sure to keep the lifter cable taut so that
the long drivers used to keep the lifter are slightly
the
0009-2155
[1]
F-2-6
0009-4912
lifted by the cable.
5) Fix the 2 pulleys [5] in place to the lifter drive shaft
with a set screw [9] (1 pc. each).
6) Fit all removed pulleys to the lifter shaft; then,
measure the height A from the base plate of the
compartment to the top face of the lifter, thus
making sure that the lifter is level.
[1]
[7]
[6]
[A]
[5]
[9]
[8]
[3]
[5]
2.2.3 Points to Note When
Mounting the
Pikcup Roller
Front of the Machine (collar [3]; silver-colored)
It has its own direction of rotation [1]; when mounting
the deck pickup roller [2] to the front of the machine,
be sure that the marking [4] found on the collar [3] is
to the front of the machine.
Rear of the Machine (collar [7]; gold-cover)
It has its own direction of rotation [6]; when mounting
the deck pickup roller [6] to the rear of the machine,
be sure that the marking [8] found on the collar [7] is
to the rear of the machine.
Chapter 2
[7]
[5]
[8]
[A]
[9]
[5]
[A]
[2]
[4]
[A]
F-2-7
Deck
0009-4911
2-3