Electrical Connection - Multipole Connectors (Topcontrol Type 8630); Marking Of The Multipole Plugs Or Sockets And The Contacts - Burkert 2702 Operating Instructions Manual

C
ommissioning
eleCtRICal ConneCtIon - MUltIPole ConneCtoRs
(toPCONTROL tYPe 8630)
attentIon!
For connection to the technical earth (ground) (TE), a threaded stud with nut is provided on
the connection module. To assure electromagnetic compatibility (EMC), connect this stud to
a suitable earthing (grounding) point using as short a cable as possible (max. 30 cm).
note
Use of the 4 - 20 mA setpoint input
If the voltage supply of a TOPControl device fails in a row of such devices connected in
series, the input of the failed device will become high-impedance. This will cause the 4 -
20 mA standard signal to fail. If this occurs, please contact Bürkert Service directly.
With Profibus DP or DeviceNet:
The markings of the multipole plugs and sockets, and the contacts are to be found in the
respective chapters.

Marking of the multipole plugs or sockets and the contacts

M16
M8
Output signals
to SPS
Process value
18 - 2702
M12
M8
Operating voltage
TE
Initiators (inductive proximity switches)