Misfeed In The Upper Exit Area (When A Job Separator Tray Kit Or Finisher (Mx-Fn13) Is Installed); Misfeed In An Output Tray (When A Finisher (Mx-Fn13) Is Installed) - Sharp TINSE2026QSZZ Operation Manual

MISFEED IN THE UPPER EXIT AREA
(when a job separator tray kit or finisher (MX-FN13) is installed)
If a job separator tray kit or a finisher is installed, a misfeed may occur in the upper exit area.
1
Open the upper right side cover.
MISFEED IN AN OUTPUT TRAY
(when a finisher (MX-FN13) is installed)
1
Open the front cover.
2
While pressing the lever over to the
left, slide the finisher to the left until it
stops.
3
Turn roller rotating knob in the
direction of the arrow to remove the
misfed paper.
Gently slide the finisher
until it stops.
TROUBLESHOOTING AND MAINTENANCE
2
Gently pull the misfed paper out.
3
Close the upper right side cover.
Make sure that the misfeed message is cleared.
4
Slide the finisher back to the right.
5
Close the cover.
Be careful not to tear the
misfed paper during
removal.
133
7