Stapled Output Does Not Collect Neatly; Other Problems; The Display Screen Is Difficult To View; You Were Logged Out Without Having Performed Logout Yourself - Sharp MX-C380P Operation Manual

Problem
Stapled output does
not collect neatly.

OTHER PROBLEMS

Problem
The display screen is
difficult to view.
You were logged out
without having
performed logout
yourself.
You forgot the
administrator
password.
The actuator came off
(when a finisher is not
installed)
Point to check
Is the paper curled?
Point to check
Is the display contrast properly
adjusted?
Did Auto Clear activate?
Was the administrator password
changed from the factory default
setting?
When removing printed output, do you
forcefully lift the paper up or fold the
paper?
It may help to turn the paper over in the paper tray.
Adjust the display contrast with "Display Contrast" in the
system settings.
When user authentication is used, the currently logged
in user will be automatically logged out if Auto Clear
activates.
Log in again.
If you are the administrator, you can change the time
setting of Auto Clear or disable Auto Clear in "Auto
Clear Setting".
➞ System Settings (Administrator) (Web page only) >
"Operation Settings" > "Other Settings" > "Auto Clear
Setting"
Contact your dealer or nearest SHARP Service
Department.
For the factory default administrator password, see "TO
THE ADMINISTRATOR OF THE MACHINE" in the
Safety Guide. After changing the password, take special
care to remember it.
While removing the output, if you forcibly pull up or fold
the output, the actuator may come off.
If the actuator comes off, follow the steps below to
reattach it.
(1) Lift the mount for the actuator with your finger.
Hold the mount with your finger.
(2) Insert in the direction of the arrow as far as the
actuator will go.
Do not forcibly press the actuator into the mount.
The actuator may break.
(2)
Actuator
Orientation of the actuator
Top side
4-22
TROUBLESHOOTING
Solution
Solution
(1)
When attaching the
actuator, make sure
it is attached with
the top side up.