Peripheral Adjustment; Saddle Finisher (When The 100-Sheet Saddle Finisher Is Installed); Staple Position Adjustment; Paper Alignment Width Adjustment For Staple Position - Sharp MX-6500N Adjustment Manual

3 Peripheral Adjustment

Select [Peripheral Adjustment] in the Machine Adjustment
screen.
Adjustable options:
The saddle finisher, trimming module, finisher, punch
module, and folding unit can be adjusted:
The installed options are displayed as follows:
 When the100-sheet saddle finisher, trimming module
and punch module are installed:
3.1
Saddle Finisher (When the 100-sheet saddle
finisher is installed)
3.1.1

Staple Position Adjustment

This performs staple position adjustment in the direction of
paper width.
1) Select [Staple Position Adjustment] in the Saddle
Finisher screen.
2) Adjust the staple positions in the direction of paper
width.
The 10-key pad appears when each of the textboxes is
tapped. Enter the desired values.
Input range:
One staple: [70]-[130]
Two staples: [85]-[115] (1 = 0.1 mm)
Default: 100 for each
Note:
Staple position in paper feed direction cannot be
adjusted.
Functional restriction
For 2 staples, the staple positions that can be adjusted
vary depending on the paper size and the number of
sheets included in a set to be stapled as the following table
shows:
Paper size Number of
sheets
included in
a set
20 sheets or
A4R/Letter R less
or smaller
More than 20
sheets
Larger than
-
A4R/Letter R
3.1.2 Paper Alignment Width Adjustment for
Staple Position
This performs jogger width adjustment for staple (paper
width direction).
Set this adjustment when the stapled stuck of paper is not
aligned.
1) Select [Paper Alignment Width Adjustment for Staple
Position] in the Saddle Finisher screen.
2) Adjust the distance between the alignment plates in the
direction of paper width for stapling.
The 10-key pad appears when the textbox is tapped.
Enter the desired value.
23
Staple position that
can be adjusted
Only the staple at back
Both staples at front
and back
Both staples at front
and back