Points To Note When Making Copies - Sharp TINSE2026QSZZ Operation Manual

POINTS TO NOTE WHEN MAKING COPIES

Document glass and RSPF
• Paper in a different orientation from the original can be selected if the auto paper select or auto image function has
been selected. In this case, the image of the original will be rotated.
• When copying a book or an original that has been folded or crumpled, press down gently on the RSPF. This will
reduce shadow lines caused by uneven contact between the original and the document glass.
• When the center tray counter function is enabled, the number of pages that can be delivered to the output tray is
limited to 500 (A4 and 8-1/2" x 14" sizes only; the limit for all other sizes is 300 pages.). When the offset function is
used, the limit is approximately 300 pages. When the limit is reached, copying stops and the [START] key ( ) light
turns off. Remove the copies from the center tray and then press the [START] key ( ) to resume copying. The
center tray counter function can be disabled in the administrator settings. (See "6. SYSTEM SETTINGS
(ADMINISTRATOR)".)
Originals that can be used in the RSPF
A maximum of 100 sheet originals of equal size (8-1/2" x 11", 24 lbs. (90g/m
of different length can be placed together in the RSPF as long the widths are equal; however, some copy functions
may not operate correctly.
Acceptable originals
Originals of size 5-1/2" x 8-1/2" to 11" x 17" having a weight of 9 lbs. to 34 lbs. (35g/m
2 2
lbs. (52g/m to 105g/m ) for two-sided originals can be used.
Other considerations
• Use originals that are within the specified size and weight ranges. Originals outside the specified ranges may
cause misfeeds.
• Make sure that there are no paper clips or staples on the original.
• If an original has damp spots from correction fluid or ink, or glue from pasteups, be sure it has dried completely
before using it to make a copy. Otherwise the interior of the RSPF or the document glass may become soiled.
• The following originals cannot be used. These may cause misfeeds, smudging, and unclear images.
• Transparencies, tracing paper, other transparent or translucent paper, photographs
• Carbon paper
• Thermal paper
• Originals that are creased, folded, or torn
• Glued originals, cut-out originals
• Originals with binder holes
• Originals printed using an ink ribbon (thermal transfer printing), originals printed on thermal transfer paper
COPY FUNCTIONS
2
)) can be placed in the RSPF. Originals
2 2
to 128g/m ) or 14 lbs. to 28
2
25