Leica RM2245 Instruction Manual page 18

4. Startup
4.3 Unpacking and installation
Fig. 10
18
(cont.)
5 5 5 5 5
6 6 6 6 6
7 7 7 7 7
8 8 8 8 8
9
• Take out the fixing module (5). To do so,
hold it by the top edge of the module and
in the recessed grip (6) and pull it out by
pulling upwards.
• Lift the instrument (7) by holding it by the
base plate and under the instrument on
the back and lift it out of the formed cush-
ion (8).
Never hold the instrument for
transport by the handwheel or the
rotary knob for section thickness
adjustment.
• Place the instrument on a stable labora-
tory table.
The two sliding elements (9) located on
the rear of the base plate make it easier
to move the instrument on the table.
• To move the instrument, hold it by the
front of the base plate, lift it up gently and
slide it on its slides.
Observe the correct resting angle
to the table to avoid pinching
your fingers.
Instruction manual V 1.6 – 10/2009