ProMinent DULCOMETER D1C Operating Instructions Manual page 12

8 Complete Operating Menu / Overview
All parameters of the controller can be set in the complete operating menu (access see previous page). The
following overview shows the settings which can be selected:
1.00
mea val. 1.00 ppm
fd. fwd.:
reg. val.:
w:
calibration O
zero p.: 4.00 mA
slope:
1.60 mA/ppm
meas. range
setting ?
measured value
setting ?
meas. parameter
setting ?
correction value
setting ?
pumps
setting ?
relays
setting ?
limits
setting ?
12
Permanent display 1
ppm
Permanent display 2
70 %
only with control
-59 %
(w = setpoint)
2.00 ppm
2
Only with correction
variable
Only with pumps
Only with limit relay,
solenoid valve relay
or servomotor
Number and scope of setting menus
is dependent on the device.
Access to setting menus can
be blocked with access code.
servomotor
setting ?
control
setting ?
feed forward ctrl.
setting ?
signal output 1
mA setting ?
signal output 2
mA setting ?
general setting
information
Only with servomotor
Only with control
Only with feed
forward control
Only with
standard
signal output
Only with
2 standard
signal outputs
D1C2-O2-017-GB