Figure 12.
DNS (IP) — Press the
•
◄ and ► Navigation buttons to move the cursor position and the Keypad to enter
values. The range is 0.0.0.0 to 255.255.255.255 (the default is 127.0.0.1).
•
Domain name — Displays the domain name.
•
MAC address — Displays the MAC hardware address of the interface.
Display Submenu
This submenu (see figure 13) contains settings to adjust the display and sleep timer.
Figure 13.
Auto brightness mode — Press the ◄ or ► Navigation button to enable or
•
disable the auto brightness feature. When enabled, the LCD screen and button
illumination levels are automatically adjusted to the amount of ambient room light.
Brightness level — Press the ◄ and ► Navigation buttons to select the brightness
•
level of the LCD screen. When this is set, the auto brightness feature is disabled.
Sleep timer mode — Press the ◄ or ► Navigation button to enable or disable
•
sleep mode. Sleep mode activates after a certain amount of time of inactivity passes.
The time is determined by the sleep timeout setting.
To deactivate Sleep mode after it has been activated, perform one of the following:
Press a button on the front panel.
•
With wake on motion mode enabled, make a motion near the device.
•
Sleep timeout period — Press the ◄ and ► Navigation buttons to select the
•
period of inactivity (in minutes) required to activate sleep mode.
CCI Pro 700 TouchLink Pro Conference Room Control Interface • Setup Menu
Network Submenu — Page 2
]
Navigation button to edit the DNS address. Use the
Display Submenu
14