Extron electronics TouchLink CCI Pro 700 User Manual page 16

Touchlink pro conference room control interface
Hide thumbs Also See for TouchLink CCI Pro 700:
Table of Contents

Advertisement

Pins:
1 2 3 4 5 6 7 8
Side View
Insert Twisted
Pair Wires
RJ-45 Connector
Figure 6.
Plug one end of the cable into the RJ-45 connector and the other end into a network
switch, hub, or router that is connected to an Ethernet LAN or the Internet. An Extron
IP Link Pro control processor must also be connected to the same network domain.
The network port has two LEDs. The green LED lights when a network connection is
established. The yellow LED blinks when data is passed to or from the interface.
ATTENTION:
ATTENTION : Le CCI Pro 700 est compatible avec l'alimentation POE via Ethernet
NOTE: Power over Ethernet is required to power the device.
To use a power injector, connect a straight-through Ethernet cable to the power supply
and a switch or router. This cable carries network information from the switch or router
to the power injector input. Connect a second straight-through cable between the
power injector and the CCI Pro 700 to carry the network information and 48 VDC from
the power injector to the interface. Connect the IEC power cord to a convenient
100 VAC to 240 VAC, 50-60 Hz power source.
Figure 7 below shows the Extron XTP PI 100. Your power injector may look different.
100-240V
0.4A MAX
To a
network switch
Figure 7.
CCI Pro 700 TouchLink Pro Conference Room Control Interface • Panel Features
Straight-through Cable
End 1
End 2
Pin Wire Color
Pin Wire Color
1
white-orange
1
white-orange
2
orange
2
orange
3
white-green
3
white-green
4
blue
4
blue
5
white-blue
5
white-blue
6
green
6
green
7
white-brown
7
white-brown
8
brown
8
brown
RJ-45 Connector Pinout Tables
The CCI Pro 700 is Power over Ethernet (PoE IEEE 802.1af, class 3)
compliant. Do not connect power before reading the Attention notification on
page
9.
(PoE 802.3af, classe 3). Ne branchez pas de sources d'alimentation externes
avant d'avoir lu les mises en garde sur
~
50-60Hz
XTP
XTP PWR
PWR
To the
CCI Pro 700
Connecting the Power Injector
Crossover Cable
End 1
Pin Wire Color
Pin Wire Color
1
white-orange
1
2
orange
2
3
white-green
3
4
blue
4
5
white-blue
5
6
green
6
7
white-brown
7
8
brown
8
page
9.
End 2
white-green
green
white-orange
blue
white-blue
orange
white-brown
brown
8

Advertisement

Table of Contents
loading

Table of Contents