Sharp IG-DL1Y Operation Manual page 9

Adjusting the direction of ion outlet
The distance from the outlet to the bed sheet (mattress) become approximately 70 cm.
Adjust the bending the arm and installing position of the stand or clamp.
<Installation using the stand >
Adjust the arm to the left, right, and front within
roughly 90°. Do not bend the arm backward.
(This is also the case when installation using
the clamp.)
• Do not bend the arm as if you are folding it.
• In installation using the stand, do not bend the arm backward too. It may fall depending on
the installation state.
<Installation using the clamp >
Arm
Bending part is only
near the center of
the the arm.
Stand
E-7
Arm
Clamp
Left less
°
than 90
Forward less
than 90 °
Right less
°
than 90