Troubleshooting - Sharp IG-DL1Y Operation Manual

TROUBLESHOOTING

Before calling for service, please review the TROUBLESHOOTING chart below.
The problem may not be unit malfunctions.
Problem
The Plasmacluster Ion Generator
does not work.
FILTER
CLEAN
UNIT
Flashing
(red)
FILTER
CLEAN
UNIT
FILTER
CLEAN
Lighting
(orange)
UNIT
A discontinuous noise is heard.
A clicking or ticking sound
comes from the unit.
Color of the spotlight
The spotlight cannot be turned on.
The discharged air has odor.
• Is the plug connected properly?
Please be connected defi nitely.
• Is a Plasmacluster Ion Generating Unit inserted
properly? Insert Plasmacluster Ion Generating Unit
correctly.
• It's time to replace Plasmacluster Ion Generating
Unit. Replace with a new Plasmacluster Ion
RESET
Generating Unit.
Press
3 Sec.
• Approx. 17,500 hours to approx. 19,000 hours:
• More than approx. 19,000 hours: Unit Replacing Light
• Plasmacluster Ions are not released.
• Is any dust on the electrode section of the unit? Clean the
RESET
Press
3 Sec.
• Is the Plasmacluster Ion Generating Unit installed
Flashing
(blue)
• Filter is getting dirty. Clean the fi lter.
RESET
After cleaning the filter, press the Filter Reset
Press
3 Sec.
Button for 3 seconds.
• The Filter Clean Light blinks twice and it turns off.
Press for
3 sec.
• Clicking or ticking sound may be audible when the unit
is generating ions.
• Although the color of the spotlight may differ slightly
depending on the product, there is no problem with the
intensity.
• Is a plug connected properly?
Please be connected defi nitely.
• Is the operation switch at the "
Move the operation switch to the "
• Filter is getting dirty. Clean the fi lter.
• The Plasmacluster Ion Generator releases a small
trace of ozone which may produce odor. This is not
detrimental to health.
WHAT TO DO
Unit Replacing Light (red) is fl ashing.
(red) is fl ashing faster and stops operation.
electrode section with the attached unit cleaning brush or
commercial cotton swabs. If cleaning is insuffi cient, the
light may start fl ashing again.
correctly? Remove the unit, fully inserted again and
set the Operation Switch to turn ON. If the Operation
Light (blue) flashes repeatedly, contact the store you
purchased or Sharp Service Center.
E-12
" position?
" position.