Important Safety Instructions; Warning; Cautions Concerning Operation; Installation Guidelines - Sharp IG-DL1Y Operation Manual

IMPORTANT SAFETY INSTRUCTIONS

When using electrical appliances, basic safety precautions should be followed, including the following:
WARNING - To reduce the risk of electric shock, fi re or injury :
• Read all instructions before using the unit.
• Use only a 220-240 volt outlet.
• Do not damage or modify power cord. Also, do not use the power cord if it is damaged.
• Do not remove the plug when your hands are wet.
• Do not use the unit if the power cord or plug is damaged, or the connection to the wall outlet is loosened.
• Insert the plug securely all the way into power socket until it stops.
• When cleaning the unit, stop the operation and pull out the plug from the outlet.
• Periodically remove dust from the plug.
• If a defect is generated (burning smell etc.), stop the operation and pull out the plug from the outlet.
(Doing so could lead to fi re or electric shock.) Contact the store you purchased this appliance from or
Sharp Service Center.
• Do not insert fi ngers or foreign objects into the air intake or air outlet.
• Do not modify the product. Also, no one other than an authorized repairman should take apart
or repair the product. (Doing so could lead to fi re, electric shock or injury.) Contact the store you
purchased the appliance from or Sharp Service Center.
• Do not use or install the unit in unstable places. (The unit could fall, resulting in injury or damage.)
• Do not put the unit in the water, do not sprinkle water on the unit, or do not put water directly in the
unit. (Doing so could lead to fi re or electric shock.)
• Do not use chlorine-based or acid detergent for cleaning. (Doing so could lead to generation of toxic
gas from detergent, damaging health.)
• Do not cover the unit with easily burnable objects such as paper or cloth, or do not put them close to the unit.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.

CAUTIONS CONCERNING OPERATION:

• Do not pull on the cord when unplugging the plug. (Doing so could lead to leading to fi re or electric
shock.)
• If you do not use the product for a long time, remove the plug from the outlet.
• Do not use the product at the following places.
• Places where water may be sprinkled or humid places such as a bathroom.
• Places where oil components such as edible oil are fl oating.
• Places where hair spray or chemicals are used such as barber shops or hair salons, or cleaners.
• Do not look in the spotlight, or do not put the light directly in the eyes. (Doing so could lead to damage
to the eyes.)
• When installing in a bed or a table, avoid places inappropriate for installation. (The unit could fall.)
• Do not forcibly rotate, pull, or bend the unit, or subject it to shocks or vibration.
• Do not carry or move the unit with the stand (or clamp) attached. (The unit could fall, resulting in injury
or damage.)
• Do not use items of silicone-containing products* near the unit. The fl uororesin or silicone could get
stuck inside the unit, preventing it from producing Plasmacluster ions. If this happens, remove the
dust from the electrode section of the Plasmacluster Ion Generating Unit. (See E-9)
* Hair care products (split end coatings, hair mousses, hair treatments, etc.), cosmetics, antiperspirants,
antistatic agents, waterproofi ng sprays, polishes, glass cleaners, chemical impregnated clothes, wax, etc.

INSTALLATION GUIDELINES:

• Do not block the air inlet and/or air outlet.
• Place at least 2m away from equipment utilizing electric waves such as televisions or radios to avoid
electrical interference when using the unit.
• Appropriate room temperature is between 0-35ºC.
• Install the clamp to a place that can withstand tightening of the clamp or operation of the arm. The
thickness that can be clamped is from 25 mm to 50 mm.
E-2