Sharp IG-DL1Y Operation Manual page 7

Installation using the clamp
There are two ways of installation using the clamp. It can be set to vertical or horizontal.
①
Attach the clamp. (See the instructions below.)
②
Ensure that the connecting part is inserted all the way in the
insertion section of the clamp.
Ensure that the fi xing tabs of the connecting part are inserted and lock in the clamp.
(You can hear a clicking sound.)
<Vertical installation of the clamp>
Connecting
part
Insert
Clamp
Insertion
section
Clamp fi xing handle
Avoid installations shown below.
Clamping Board is
allowance is too thin
insuffi cient
Note:
To remove the unit from the stand, press and hold the both (right and left) installing tabs and lift.
(To the backrest of the
bed etc.)
Installing
section
25 - 50
mm
Board is Round
too thick pipe
<Horizontal installation of the clamp>
(To the side table etc.)
Connecting
part
Insert
Clamp
Insertion
section
Clamp fi xing
handle
Installation Uneven
from the place
under side
E-5
Installing
section
25 - 50
mm
Connecting part
Installation in which the
connecting part is facing
sideways