Figure 10: New Entry On The "Database" Results Page - PLUSOPTIX A12C Short Manual

After confirming the entered or selected patient data, you will be returned to the previous
results page. The name of the patient (or patient ID) is shown in the header. A database
entry (see Figure 10) has been created on the "database" results page, the measurement
report is saved on the SD card and a print job has been sent via the infrared interface (see
supplementary short manual 6). If the patient has been retrieved from the database, all this
patient's saved measurement values are shown.
New measurement
Saved
measurements

Figure 10: New entry on the "database" results page

From the patient data overview, you can:
Measure the entered or selected patient in the pre-selected measurement mode
by pressing the trigger.
Carry out a measurement of the entered or selected patient in another
measurement mode (e.g. monocular). To do this, touch the green checkmark in
the navigation bar to carry over the previously entered or selected patient data for
the next measurement.
Return to the home page by touching the red "X" button". Previously entered or
selected patient data is discarded.
Seite 8 von 11
Deleting
displayed
patients including
all measurements
(see
Chapter 6)
Deleting
displayed
measurements
(see
Chapter 6)