Deleting Entries From The Database; Figure 12: Deleting Entries From The Database; Figure 13: Deleting Patients From The Database - PLUSOPTIX A12C Short Manual

6 Deleting entries from the database

Saved measurement values can be deleted from the database.
Touch the measurement that you want to delete and then touch the Delete button (1) at the
right next to the label. Confirm the confirmation prompt with the green checkmark (2).
Selecting the
measurement
Deleting
displayed
measurements

Figure 12: Deleting entries from the database

If you want to delete the patient along with all saved measurement values, touch the symbol
(1) next to the entry fields and then confirm the confirmation prompt by touching the green
checkmark (2).
Deleting
displayed
patients
including all
measurements

Figure 13: Deleting patients from the database

If you do not want to delete the measurement values or patient, reject the selection by
touching the red "X" (3) in the navigation bar. By touching the red "X" (3) or trigger again, you
will return to the home page.
Deleting the whole database
If necessary, the entire database can be deleted at once. Connect a USB stick and go to the
settings menu. Touch the button (4) to delete the database and follow the instructions.
A back-up copy of the database is stored on the USB stick and can be restored by importing
this back-up copy again. For more information about importing patient data, refer to chapter 5
"Importing patient data via the USB interface".
1) 2) 3) 4)
Seite 11 von 11