Configuration; Turn The Audible Alarm On/Off; Set An Access Code - Thermo Scientific 310 User Manual

Turn the Audible
Alarm ON/OFF

Set an Access Code

Thermo Scientific

Configuration

Section 3
Several features available in Configuration Mode allow custom setup of the
incubator. These features are listed and described below. All features may
not be necessary in all applications, but are available if needed. To enter
Configuration mode, press the Mode key until the Config indicator lights.
Press the right and/or left arrow until the appropriate parameter appears in
the message center. See Chart 3-1 for more detail.
The audible alarm can be turned on or off. The factory setting is ON.
1. Press the Mode key until the Config indicator lights.
2. Press the right arrow until Audible XXX is displayed in the message
center.
3. Press up/down arrow to toggle Audible ON/OFF.
4. Press Enter to save the setting.
5. Press the Mode key to return to run mode or right/left to go to
next/previous parameter.
A 3-digit Access Code can be entered to avoid unauthorized personnel
from changing the setpoints, calibration, or configuration. A setting of
000 will bypass the access code. The factory setting is 000.
1. Press the Mode key until the Config indicator lights.
2. Press the right arrow until Acc Code XXX is displayed in the message
center.
3. Press up/down arrow to change the access code.
4. Press Enter to save the access code.
5. Press the Mode key to return to the Run mode or right/left to go to
next/previous parameter.
Model 310 Series DH Incubator 3-1