Adding Or Replacing Memory - HP Elitebook 820 G1 Getting Started

Adding or replacing memory

Adding or replacing memory modules
The computer has two memory module slots. The capacity of the computer can be upgraded by
adding a memory module to the vacant expansion memory module slot or by upgrading the existing
memory module in the primary memory module slot.
WARNING!
cord and remove all batteries before installing a memory module.
CAUTION:
any procedure, ensure that you are discharged of static electricity by touching a grounded metal
object.
NOTE: To use a dual-channel configuration when adding a second memory module, be sure that
both memory modules are identical.
To add or replace a memory module:
CAUTION:
Shut down the computer before adding or replacing memory modules. Do not remove a memory
module while the computer is on, in the Sleep state, or in Hibernation.
If you are not sure whether the computer is off or in Hibernation, turn the computer on by pressing the
power button. Then shut down the computer through the operating system.
1. Save your work and shut down the computer.
2. Disconnect AC power and external devices connected to the computer.
3. Turn the computer upside down on a flat surface.
4. Remove the battery (see
(see Removing or replacing the service door on page
5. If you are replacing a memory module, remove the existing memory module:
a. Pull away the retention clips (1) on each side of the memory module.
The memory module tilts up.
66 Chapter 10 Maintenance
To reduce the risk of electric shock and damage to the equipment, unplug the power
Electrostatic discharge (ESD) can damage electronic components. Before beginning
To prevent information loss or an unresponsive system:
Inserting or removing the battery on page 32) and the service door
43).