Wheel Alignment Standard Values; Front Alignment (Inspection Value); Rear Alignment (Inspection Value) - Subaru Forester 2019 Repair Manual

18.Wheel Alignment Standard Values

A: SPECIFICATION

1. FRONT ALIGNMENT (INSPECTION VALUE)

Suspension height
+12 mm
(Tolerance: (
–24 mm
Camber (tolerance: 0°30 Differences between RH and LH: 35 or less)
Caster (referential value)
Steering angle (tolerance: 1.5°)
Toe-in
Kingpin angle (referential value)

2. REAR ALIGNMENT (INSPECTION VALUE)

Suspension height
+12 mm
(Tolerance: (
–24 mm
Camber (tolerance: 0°45 Differences between RH and LH: 45 or less)
Toe-in
Thrust angle (tolerance: 0°0030)
NOTE:
• Adjust with the value less than the inspection value, taking aging variation into consideration.
• Front toe-in, rear toe-in and front camber can be adjusted. Adjust if the value of toe-in or camber exceeds
the tolerance range of the specification chart.
• Other items except for front toe-in, rear toe-in and front camber that are described in the specification chart
cannot be adjusted.
• If other items exceed the tolerance range of the specification chart, check the suspension parts and con-
nections for deformation. If defective, replace them with new parts.
B
A – B = Positive: Toe-in, Negative: Toe-out

= Individual toe angles
Wheel Alignment Standard Values
+0.47 in
))
–0.94 in
+0.47 in
))
–0.94 in
A
mm (in)
Inner wheel
Outer wheel
mm (in) 03 (00.12) Toe angle (sum of both wheels): 0°0°15
mm (in)
mm (in)
Toe angle (sum of both wheels): IN 0°1515
B
BS - 325
64 (2.52)
-0°05
5°22
38.4°
33.5°
13°31
-75 (-2.95)
-0°50
IN 33 (IN 0.120.12)
0°00
A
FS-10184