Jack/Lift Points - Subaru Forester 2019 Repair Manual

3. Jack/Lift Points

A: CAUTION
When using a lift or shop jack to raise a vehicle or using rigid rack to support a vehicle, always follow instruc-
tions concerning jack-up points and weight limits to prevent the vehicle from falling, which could result in in-
jury. Be especially careful that the vehicle is balanced before raising it. Be sure to set the wheel stoppers
when jacking-up only the front or rear side of the vehicle.
CAUTION:
Select the lift attachment so that the side sill does not contact the lift arm.
NOTE:
• When using a lift, follow its operation manual.
• When the side sill cover contacts the lift arm, use a lift attachment.
• Do not work or leave unattended while the vehicle is supported with jack, support it with rigid racks.
• Be sure to use the rigid racks with rubber attached to cradle to support the vehicle.
• When using a lift, use an attachment or something similar.
• When using a plate lift, use a rubber attachment. Place the attachment to the specified position of the ve-
hicle, by adjusting front/rear and left/right sides accordingly.
(A)
(B)
(A) 80 mm (3.1 in) or more
(B) 80 — 100 mm (3.15 — 3.94 in)
(C) 120 — 200 mm (4.72 — 7.87 in)
• Align the cushion rubber center part of plate lift with the center part of rubber attachment.
• Do not use the plate lift whose attachment does not reach the supporting locations.
Jack/Lift Points
(C)
NT-00070
BS - 17